Measures to solve the leakage caused by the discharge door of the mixing plant host not being tightly closed

During the production and use of concrete mixing plants, it is common to encounter situations where the discharge door is not tightly closed, resulting in material leakage. After such problems occur, it not only leads to a decrease in the quality of concrete, but also affects the production efficiency of the mixing plant and the service life of equipment. Therefore, some measures must be taken to address such issues.

Firstly, it is necessary to check whether the sealing and fixation of the discharge door are secure. If the sealing is not good, special sealing materials such as rubber strips, sealing strips, etc. can be used for treatment. If the door is not securely fixed, simple repairs can also be carried out, such as replacing screws, strengthening installation, etc.

Secondly, it is necessary to inspect and optimize the operation mode of the discharge door. Some of the main discharge doors installed in concrete mixing plants are electric, so it is necessary to check whether the electrical control system is normal and whether there are any adverse reactions. In addition, it is necessary to check whether the motor or cylinder is functioning properly and whether it needs to be replaced or repaired.

Once again, it is necessary to inspect the feeding system and mixing system of the mixing plant. If the mix proportion of concrete is unreasonable and the feeding is not uniform enough, there will be blockage or excess, which will cause the problem of leakage of the discharge door. If the mixing time is too long or too short, it can also affect the fluidity of the concrete, leading to leakage of the discharge door.

Finally, it is necessary to promptly clean up the accumulated material inside the mixing plant. Because the concrete mixing plant is used for a long time, it is easy to accumulate a large amount of concrete residue in the equipment, which can lead to problems such as the discharge door not being tightly closed and the flow reaction not being sensitive. Therefore, it is necessary to regularly clean and maintain the mixing plant, clean up accumulated materials in a timely manner, and keep the equipment clean and tidy.

Note: The article is sourced from the internet. If there is any infringement, please contact us to delete it. Thank you.